Manualshelf

Specifications

ManualsBrandsCisco ManualsPrint & ScanFourth-Generation Versatile Interface Processor VIP4
75767778798081828384
4-19
Cisco PA-FE-TX and Cisco PA-FE-FX Fast Ethernet 100BaseT Port Adapter Installation and Configuration
OL-2899-02
Chapter 4 Configuring the PA-FE-TX or PA-FE-FX
Checking the Configuration
Encapsulation HDLC, loopback not set, keepalive set (10 sec)
[Additional display text omitted from this example]
Router# show interfaces serial 3/2
Serial3/2 is up, line protocol is up
Hardware is M8T-RS232
Internet address is 10.0.0.2
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive set (10 sec)
[Additional display text for remaining interfaces omitted]
Note To use the show interfaces command with the Cisco 7140 series router, replace the interface address
arguments 3/0, 3/1, 3/2, 3/3, 3/4, 3/5, 3/6, and 3/7 with 4/0, 4/1, 4/2, 4/3, 4/4, 4/5, 4/6, and 4/7,
respectively.
Cisco 7200 Series Routers, Cisco 7200 VXR Routers, and Cisco uBR7200 Series Routers—Example Output of the show interfaces
Command
Using the show interfaces type module-slot-number/interface-port-number command displays the
status information about a specific type of interface—in these examples, a serial interface.
Following is an example of the show interfaces command for Cisco 7200 series and Cisco uBR7200
series routers. In this example, the eight serial interfaces (0 to 7) are on a module in slot 1; also, most of
the status information for each interface is omitted. (Interfaces are administratively shut down until you
enable them.)
Router# show interfaces serial 1/0
Serial1/0 is up, line protocol is up
Hardware is M8T-RS232
Internet address is 10.0.0.0
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive set (10 sec)
[Additional display text omitted from this example]
Router# show interfaces serial 1/1
Serial1/1 is up, line protocol is up
Hardware is M8T-RS232
Internet address is 10.0.0.1
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive set (10 sec)
[Additional display text omitted from this example]
Router# show interfaces serial 1/2
Serial1/2 is up, line protocol is up
Hardware is M8T-RS232
Internet address is 10.0.0.2
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive set (10 sec)
[Additional display text for remaining interfaces omitted]