Specifications

4-14
Cisco PA-FE-TX and Cisco PA-FE-FX Fast Ethernet 100BaseT Port Adapter Installation and Configuration
OL-2899-02
Chapter 4 Configuring the PA-FE-TX or PA-FE-FX
Checking the Configuration
Cisco 7000 Series Routers—Example Output of the show diag Command
Following is an example of the show diag command from a Cisco 7000 router that shows two modules
installed in slot 0 and slot 1 on a VIP2 in interface processor slot 3:
Router# show diag 3
Slot 3:
Physical slot 3, ~physical slot 0x7, logical slot 3, CBus 0
Microcode Status 0x4
Master Enable, LED, WCS Loaded
Board is analyzed
Pending I/O Status: None
EEPROM format version 1
VIP2 controller, HW rev 2.2, board revision UNKNOWN
Serial number: 03341418 Part number: 73-1684-02
Test history: 0x00 RMA number: 00-00-00
Flags: cisco 7000 board; 7500 compatible
EEPROM contents (hex):
0x20: 01 15 02 02 00 32 FC 6A 49 06 94 02 00 00 00 00
0x30: 07 2B 00 2A 1A 00 00 00 00 00 00 00 00 00 00 00
Slot database information:
Flags: 0x4 Insertion time: 0x3188 (01:20:53 ago)
Controller Memory Size: 8 MBytes
PA Bay 0 Information:
Token Ring PA, 4 ports
EEPROM format version 1
HW rev 1.1, Board revision 0
Serial number: 02827613 Part number: 73-1390-04
PA Bay 1 Information:
Token Ring PA, 4 ports
EEPROM format version 1
HW rev 1.1, Board revision 88
Serial number: 02023786 Part number: 73-1390-04
Cisco 7100 Series Routers—Example Output of the show diag Command
Following is an example of the show diag slot command that shows a module in slot 3 of a Cisco 7120
series router:
Router# show diag 3
Slot 3:
10/100 Fast-ethernet with RJ45 Integrated module, 2 ports
Integrated module is analyzed
EEPROM contents at hardware discovery:
Hardware revision 255.255 Board revision UNKNOWN
EEPROM format version 1
EEPROM contents (hex):
0x20:01 D3 FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x30:FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
Note To use the show diag command with the Cisco 7140 series router, replace the slot argument 3 with 4.