Specifications
4-13
Cisco PA-FE-TX and Cisco PA-FE-FX Fast Ethernet 100BaseT Port Adapter Installation and Configuration
OL-2899-02
Chapter 4 Configuring the PA-FE-TX or PA-FE-FX
Checking the Configuration
Using the show diag Command
Display the types of port adapters installed in your system (and specific information about each) using
the show diag slot command, where slot is the port adapter slot.
Note The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
The following sections offer platform-specific output examples using the show diag command:
• Catalyst 5000 Family Swithces with RSM/VIP2—Example Output of the show diag Command,
page 4-13
• Cisco 7000 Series Routers—Example Output of the show diag Command, page 4-14
• Cisco 7100 Series Routers—Example Output of the show diag Command, page 4-14
• Cisco 7200 Series Routers, Cisco 7200 VXR Routers, and Cisco uBR7200 Series
Routers—Example Output of the show diag Command, page 4-15
• Cisco 7301 Routers—Example Output of the show diag Command, page 4-15
• Cisco 7401ASR Routers—Example Output of the show diag Command, page 4-16
• Cisco 7500 Series Routers with VIP—Example Output of the show diag Command, page 4-16
Catalyst5000 Family Swithces with RSM/VIP2—Example Output of the show diag Command
Following is an example of the show diag command that shows a port adapter on a Catalyst RSM/VIP2:
Router# show diag
Slot 0:
Physical slot 0, ~physical slot 0xE, logical slot 0, CBus 1
Microcode Status 0xC
Master Enable, LED, WCS Loaded
Board is analyzed
Pending I/O Status: Console I/O
EEPROM format version 1
VIP2 controller, HW rev 2.2, board revision UNKNOWN
Serial number: 03508056 Part number: 73-1554-02
Test history: 0x00 RMA number: 43-27-00
Flags: cisco 7000 board; 7500 compatible
EEPROM contents (hex):
0x20: 01 15 02 02 00 35 87 58 49 06 12 02 00 2B 1B 00
0x30: 12 2B 00 2A 1A 00 00 00 00 00 00 00 00 00 00 00
Slot database information:
Flags: 0x4 Insertion time: 0x10DC (00:01:17 ago)
Note The slot argument is not required for Catalyst 5000 family switches.