Specifications

4-6
Cisco PA-FE-TX and Cisco PA-FE-FX Fast Ethernet 100BaseT Port Adapter Installation and Configuration
OL-2899-02
Chapter 4 Configuring the PA-FE-TX or PA-FE-FX
Checking the Configuration
Using the show controllers Commands
Display all the current interface processors and their interfaces using the show controllers command.
Note The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
The following is an example of the show controllers command:
Router# show controllers
MEMD at 40000000, 2097152 bytes (unused 3360, recarves 1, lost 0)
RawQ 48000100, ReturnQ 48000108, EventQ 48000110
BufhdrQ 48000128 (2900 items), LovltrQ 48000140 (5 items, 2016 bytes)
IpcbufQ 48000150 (16 items, 4096 bytes)
IpcbufQ_classic 48000148 (8 items, 4096 bytes)
3570 buffer headers (48002000 - 4800FF10)
pool0: 9 buffers, 256 bytes, queue 48000130
pool1: 344 buffers, 1536 bytes, queue 48000138
pool2: 284 buffers, 4544 bytes, queue 48000158
pool3: 4 buffers, 4576 bytes, queue 48000160
slot2: VIP2, hw 2.4, sw 22.20, ccb 5800FF40, cmdq 48000090
software loaded from flash slot0:vip2_22-20.atmdx.191897
IOS (tm) VIP Software (SVIP-DW-M), Experimental Version 11.3
ROM Monitor version 17.0
ATM2/0/0, applique is DS3 (45Mbps)
gfreeq 48000158, lfreeq 48000168 (4544 bytes), throttled 0
rxlo 4, rxhi 284, rxcurr 1, maxrxcurr 5
txq 48001A00, txacc 48001A02 (value 284), txlimit 284
Using the show protocols Command
Display protocols configured for the entire system and for specific interfaces using the show protocols
command.
Note The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
The following is an example of the show protocols command:
Router# show protocols
line protocol is up
Router#
Using the show running-config Command
Display the running configuration file using the show running-config command.
Note The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
The following is an example of the show running-config command:
Router# show running-config