Specifications

3-3
Cisco PA-FE-TX and Cisco PA-FE-FX Fast Ethernet 100BaseT Port Adapter Installation and Configuration
OL-2899-02
Chapter 3 Removing and Installing Port Adapters
Port Adapter Removal and Installation
Caution When performing the following procedures, wear a grounding wrist strap to avoid ESD damage to
the card. Some platforms have an ESD connector for attaching the wrist strap.
Warning Hazardous voltage or energy is present on the backplane when the system is operating. Use
caution when servicing.
Port Adapter Removal and Installation
In this section there are step-by-step instructions on how to remove and install port adapters. Although
the procedures may refer to a particular type of port adapter, the steps are the same for installing and
removing all types of port adapters.
• Catalyst 5000 Family Switches with RSM/VIP2—Removing and Installing a Port Adapter, page 3-4
• Cisco 7100 Series Routers—Removing and Installing a Port Adapter, page 3-5
• Cisco 7200 Series Routers and Cisco 7200 VXR Routers—Removing and Installing a Port Adapter,
page 3-6
• Cisco uBR7200 Series Routers—Removing a Port Adapter, page 3-7
• Cisco uBR7200 Series Routers—Installing a Port Adapter, page 3-8
• Cisco 7301 Router—Removing and Installing a Port Adapter, page 3-9
• Cisco 7401ASR Router—Removing and Installing a Port Adapter, page 3-10
• Cisco 7000 Series Routers and Cisco 7500 Series Routers with VIP—Removing and Installing a
Single-Width Port Adapter, page 3-11