Datasheet

313
Release Notes for Cisco IOS Release 12.1E on the Catalyst 6500 and Cisco 7600 Supervisor Engine and MSFC
OL-2310-11
Caveats
• To use the interfaces on the FlexWAN module, you must enable IP routing on the MSFC.
(CSCdp34896)
• With an MSFC2, to avoid error-caused reloads, enter the no vines route-cache interface commands
so that VINES traffic is process switched. (CSCdr61424)
Note CSCdr61424 is not seen in later releases.
Resolved FlexWAN Module Caveats in Release 12.1(5c)E12
None.
Resolved FlexWAN Module Caveats in Release 12.1(5c)E10
None.
Resolved FlexWAN Module Caveats in Release 12.1(5c)E9
None.
Resolved FlexWAN Module Caveats in Release 12.1(5c)E8
None.
Resolved FlexWAN Module Caveats in Release 12.1(5a)E3
None.
Release 12.1(4)E1
• Open Caveats in Release 12.1(4)E1, page 313
• Resolved Caveats in Release 12.1(4)E1, page 314
Open Caveats in Release 12.1(4)E1
• Support for Mobile IP was inadvertently deleted. This problem is resolved in Release 12.1(5a)E1.
(CSCds78103)
• You cannot configure the MTU size on VLAN interfaces. For Supervisor Engine 2, this problem is
resolved in Release 12.1(8a)E. For Supervisor Engine 1, this problem is resolved in
Release 12.1(7)E. (CSCdr62024, CSCdr54103)
• The copy running-config startup-config command does not save the boot system flash command
in the startup configuration file. Use the write memory command instead. This problem is resolved
in Release 12.1(6)E. (CSCds43994)
• There is no warning message displayed if you exceed the maximum number (63) of microflow
policers. The extra policers are displayed by the show mls qos ip command, but they do not work.
If classes are increased beyond the maximum number (255) in a policy-map, the policy is rejected
without a warning message if applied to an interface. For Supervisor Engine 2, this problem is
resolved in Release 12.1(8a)E. For Supervisor Engine 1, this problem is resolved in
Release 12.1(6)E. (CSCds38349)