Datasheet

308
Release Notes for Cisco IOS Release 12.1E on the Catalyst 6500 and Cisco 7600 Supervisor Engine and MSFC
OL-2310-11
Caveats
Resolved Caveats in Release 12.1(5c)E8, page 309
Resolved Caveats in Release 12.1(5a)E3, page 311
Resolved Caveats in Release 12.1(5a)E1, page 311
Resolved Caveats in Release 12.1(5a)E, page 312
Open Caveats in Release 12.1(5c)E12
Secure shell (SSH) support does not work with MSFC2. This problem is resolved in
Release 12.1(8a)E. (CSCdt56832)
You cannot configure the MTU size on VLAN interfaces. For Supervisor Engine 2, this problem is
resolved in Release 12.1(8a)E. For Supervisor Engine 1, this problem is resolved in
Release 12.1(7)E. (CSCdr62024, CSCdr54103)
The copy running-config startup-config command does not save the boot system flash command
in the startup configuration file. Enter the write memory command instead. This problem is
resolved in Release 12.1(6)E. (CSCds43994)
No warning message displays if you exceed the maximum number (63) of microflow policers. The
extra policers are displayed by the show mls qos ip command, but they do not work. If classes are
increased beyond the maximum number (255) in a policy-map, the policy is rejected without a
warning message if applied to an interface. For Supervisor Engine 2, this problem is resolved in
Release 12.1(8a)E. For Supervisor Engine 1, this problem is resolved in Release 12.1(6)E.
(CSCds38349)
The MSFC2 does not support the MultiNode Load Balancing (MNLB) forwarding agent of the
MNLB feature set for LocalDirector. This problem is resolved in Release 12.1(8a)E. (CSCdr65433)
The ciscoFlashDeviceInitTime CISCO-FLASH-MIB object does not return the correct device
initialization (insertion or removal) time stamp for the Flash devices on a redundant supervisor
engine. Users of applications that depend on ciscoFlashDeviceInitTime should take care not to
remove a redundant supervisor engine or a PCMCIA card from slave-slot0: when the applications
are performing Flash file operations. This problem is resolved in Release 12.1(11b)E.
(CSCdp98597)
Downloading images to an Intel Value series 200 Flash card in the PCMCIA slot may in rare
situations fail to write a valid image. Downloading during periods of low system activity reduces the
likelihood of this failure. This problem is resolved in Release 12.1(6)E (see the related
Release 12.0(7)XE1 resolved CSCdm52806 caveat). (CSCdm52806)
A traceback message displays when you exit the switch console. This message is harmless and can
be safely ignored. This problem is resolved in Release 12.1(8a)E. (CSCdp35517)
Resolved Caveats in Release 12.1(5c)E12
An error can occur with management protocol processing. Please use the following URL for further
information:
http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCdw65903
This problem is resolved in Release 12.1(5c)E12. (CSCdw65903)