Datasheet

307
Release Notes for Cisco IOS Release 12.1E on the Catalyst 6500 and Cisco 7600 Supervisor Engine and MSFC
OL-2310-11
Caveats
FlexWAN Module Caveats
• Open FlexWAN Module Caveats in Release 12.1(6)E8, page 307
• Resolved FlexWAN Module Caveats in Release 12.1(6)E8, page 307
• Resolved FlexWAN Module Caveats in Release 12.1(6)E1, page 307
• Resolved FlexWAN Module Caveats in Release 12.1(6)E, page 307
Open FlexWAN Module Caveats in Release 12.1(6)E8
• Flows between an Ethernet interface configured with an HSRP standby IP address and a WAN
interface might not be Layer 3 switched. This problem is resolved in Release 12.1(8a)E.
(CSCds66364)
• FlexWAN module crashinfo files do not propagate to the MSFC bootflash device.
Workaround: Display the FlexWAN module crashinfo filename with the dir
cwanslot_number/port_adapter_number-bootflash: command. You can copy a FlexWAN module
crashinfo file with the copy cwanslot_number/port_adapter_number-bootflash: command. This
problem is resolved in Release 12.1(14)E. (CSCdr71603)
• To use the interfaces on the FlexWAN module, you must enable IP routing on the MSFC.
(CSCdp34896)
Resolved FlexWAN Module Caveats in Release 12.1(6)E8
None.
Resolved FlexWAN Module Caveats in Release 12.1(6)E1
None.
Resolved FlexWAN Module Caveats in Release 12.1(6)E
• When converting from Catalyst software to Cisco IOS, the show interfaces command for the
FlexWAN module might display “administratively down, line protocol is down.” This problem is
resolved in Release 12.1(6)E. (CSCds86384)
• Flows for packets larger than 1500 bytes might not be Layer 3 switched. This problem is resolved
in Release 12.1(6)E. (CSCds66329)
Release 12.1(5c)E and Rebuilds
• General Caveats, page 305
• FlexWAN Module Caveats, page 307
General Caveats
• Open Caveats in Release 12.1(5c)E12, page 308
• Resolved Caveats in Release 12.1(5c)E12, page 308
• Resolved Caveats in Release 12.1(5c)E10, page 309
• Resolved Caveats in Release 12.1(5c)E9, page 309