Datasheet
292
Release Notes for Cisco IOS Release 12.1E on the Catalyst 6500 and Cisco 7600 Supervisor Engine and MSFC
OL-2310-11
Caveats
Resolved Caveats in Release 12.1(8b)E9
• An error can occur with management protocol processing. Use the following URL for further
information:
http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCdw65903
This problem is resolved in Release 12.1(8b)E9. (CSCdw65903)
Resolved Caveats in Release 12.1(8b)E8
• Enhanced IGRP (EIGRP) might display a “stuck in active” message with an incorrect network and
mask (13.13.13.13 0xD0D0D0D). Routing is not affected. This problem is resolved in
Release 12.1(8b)E8. (CSCdu78538)
• With the compress-config service enabled, if the configuration file is larger than the size of
NVRAM, a “Not enough space on device” message is displayed when you enter the copy
rcp://username@servername/config_name startup-config command. This problem is resolved in
Release 12.1(8b)E8. (CSCdu24409)
• Removing the last network statement for an area from an OSPF router configuration might cause a
reload. This problem is resolved in Release 12.1(8b)E8. (CSCdw22714)
• The establishment of BGP peering might cause a spurious memory access or alignment error.
Entering a clear bgp ip command might cause alignment errors. These errors typically have no
operational impact, but with a very large number of neighbors, they might cause higher CPU usage.
This problem is resolved in Release 12.1(8b)E8. (CSCdu02357)
• When a host that has been disconnected regains connectivity, an “Attempt to overwrite Sticky ARP
entry” message might appear until the ARP table updates. This problem is resolved in
Release 12.1(8b)E8. (CSCdu53957)
• The ip cef load-sharing command was not implemented. This problem is resolved in
Release 12.1(8b)E8. (CSCdv12679)
• A Supervisor Engine 2 might display a draco2_inband_dma_pak message and reload. This problem
is resolved in Release 12.1(8b)E8. (CSCdv88786)
• Configuring a reflexive ACL on a Supervisor Engine 1 with MSFC2 might cause a reload. This
problem is resolved in Release 12.1(8b)E8. (CSCdw35672)
• The copy rcp://username@servername/config.name startup-config command fails if you specify a
destination filename. This problem is resolved in Release 12.1(8b)E8. (CSCdw20118)
• With IGMP snooping enabled, configuring static routes might cause high CPU utilization and cause
some multicast configurations to change from sparse mode to dense mode. This problem is resolved
in Release 12.1(8b)E8. (CSCdw21276)
• NDE might display LINK-2-INTVULN traceback messages every 32 seconds. This problem is
resolved in Release 12.1(8b)E8. (CSCdw29831)
• Reconfiguring ACLs might cause memory leaks. This problem is resolved in Release 12.1(8b)E8.
(CSCdw14034)
• Files cannot be deleted from slot0. This problem is resolved in Release 12.1(8b)E8. (CSCdw37558)
• With Supervisor Engine 1 and MSFC or MSFC2, memory leaks occur with Releases 12.1(8b)E6 and
12.1(8b)E7. Entering the show memory allocating-process totals | i L3 command will show that
memory allocation to the Layer 3 manager has increased. This problem is resolved in
Release 12.1(8b)E8. (CSCdw30661)