Datasheet

262
Release Notes for Cisco IOS Release 12.1E on the Catalyst 6500 and Cisco 7600 Supervisor Engine and MSFC
OL-2310-11
Caveats
• With Ethernet over MPLS, a problem may occur when the label switched path (LSP) for an Ethernet
over MPLS VC is changed and a new tunnel label for the new LSP is used. Instead of sending the
frame with the new tunnel label, the frame is sent with the old tunnel label. This problem is resolved
in Release 12.1(13)E1. (CSCdy34983)
• A mixed configuration of E3s and T3s on an AU-4 fails on OSM-1CHOC12/T3 modules. This
problem is resolved in Release 12.1(13)E1. (CSCdy76612)
• The Gigabit Ethernet WAN OSMs stop forwarding packets greater than 12K because of an ASIC
problem that causes link errors. This problem is resolved in Release 12.1(13)E1. (CSCdy70722)
Resolved OSM Caveats in Release 12.1(13)E
None.
Release 12.1(12c)E and Rebuilds
• General Caveats, page 262
• FlexWAN Module Caveats, page 267
• OSM Caveats, page 268
General Caveats
• Open General Caveats in Release 12.1(12c)E5, page 262
• Resolved General Caveats in Release 12.1(12c)E5, page 263
• Resolved General Caveats in Release 12.1(12c)E4, page 263
• Resolved General Caveats in Release 12.1(12c)E2, page 264
• Resolved General Caveats in Release 12.1(12c)E1, page 264
Open General Caveats in Release 12.1(12c)E5
• On a Layer 3 EtherChannel, applying an ACL to both the port-channel interface and a member port
prevents the ACL from denying traffic correctly.
Workaround: Remove the ACL from both the port-channel interface and the member port and
reapply it only to the port-channel interface. This problem is resolved in Release 12.1(13)E5.
(CSCdz56987)
• In a system that has policing configured and a Switch Fabric Module installed, the “AgId” field is
reset to zero in the display after an OIR of a Switch Fabric Module, and the counters may not show
packets that are policed.
Workaround: Reapply the policy, or remove and then reconfigure global QoS. This problem is
resolved in Release 12.1(13)E. (CSCdy19696)
• If you enter the do command under the interface range command, Cisco IOS executes the do
command for each interface in the range. This problem is resolved in Release 12.1(13)E.
(CSCdw92111)