Datasheet

254
Release Notes for Cisco IOS Release 12.1E on the Catalyst 6500 and Cisco 7600 Supervisor Engine and MSFC
OL-2310-11
Caveats
Resolved FlexWAN Module Caveats in Release 12.1(13)E7
None.
Resolved FlexWAN Module Caveats in Release 12.1(13)E6
None.
Resolved FlexWAN Module Caveats in Release 12.1(13)E5
• For channelized T1 interfaces, the following counters do not increment correctly:
– The “bytes in” and “bytes out” counts displayed by the show frame pvc command.
– The point-to-point pvc subinterface statistics gathered through SNMP for ifInOctets and
ifOutOctets
– The pvc statistics gathered through SNMP for frCircuitReceivedOctets and frCircuitSentOctets
– The pvc statistics gathered through SNMP for cfrExtCircuitUncompressIns and
cfrExtCircuitUncompressOuts
This problem is resolved in Release 12.1(13)E5. (CSCdz38136)
• For HSSI interfaces, the 5-minute output rate displayed by the show interface command does not
increment correctly. This problem is resolved in Release 12.1(13)E5. (CSCdz76961)
Resolved FlexWAN Module Caveats in Release 12.1(13)E4
• ATM VC bundling precedence mapping does not work. This problem is resolved in
Release 12.1(13)E4. (CSCdz61586)
• MPLS traffic drops when one E1 link of a multilink bundle fails on a PA-MC-8E1/120 port adapter.
This problem is resolved in Release 12.1(13)E4. (CSCdy76871)
Resolved FlexWAN Module Caveats in Release 12.1(13)E3
• After an OIR, a FlexWAN module may fail to save a crash-information file after a reset if it has a
Packet-over-SONET (POS) port adapter with 500 Frame Relay point-to-point DLCIs in Bay 0 and
an ATM port adapter with 500 point-to-point operation, administration, and maintenance PVCs in
Bay 1. This problem is resolved in Release 12.1(13)E3. (CSCdy18458, CSCdy09631)
• FlexWAN interfaces may go down suddenly and randomly, with the following message on the
MSFC2 console on a Cisco 7600 series router:
CBUS-3_CMDTIMEOUT: cmd timed out, CCB 0x0, slot <slot-num>, cmd code <number>
Interfaces will come up if you enter a shutdown command followed by a no shutdown command.
This problem is resolved in Release 12.1(13)E3. (CSCdy81389)
Resolved FlexWAN Module Caveats in Release 12.1(13)E1
• After you move multilink members from one FlexWAN module to another, traffic does not pass
through the multilink interface. This problem is resolved in Release 12.1(13)E1. (CSCdy24019)