Datasheet

253
Release Notes for Cisco IOS Release 12.1E on the Catalyst 6500 and Cisco 7600 Supervisor Engine and MSFC
OL-2310-11
Caveats
Resolved FlexWAN Module Caveats in Release 12.1(13)E14
• With a high traffic load, PA-A3-OC3, PA-A3-T3, and PA-A3-E3 port adapters might display an
increasing “rx_no_buffer” counter in the output of the show controllers atm privileged EXEC
command and some PVCs configured on the PA-A3 port adapter might stop receiving traffic. This
problem is resolved in Release 12.1(13)E14. (CSCin49458)
• All high-capacity counters remain at 0 for FlexWAN module POS interfaces. This problem is
resolved in Release 12.1(13)E14. (CSCdz46845)
• In a system installed with a FlexWAN and a PA-A3 ATM port adapter, the ATM interface may stay
down after you enter a shutdown command followed immediately by a no shutdown command.
This problem is resolved in Release 12.1(13)E14. (CSCdw65799)
Resolved FlexWAN Module Caveats in Release 12.1(13)E13
None.
Resolved FlexWAN Module Caveats in Release 12.1(13)E12
• ATM subinterface traffic might be incorrectly dropped. This problem is resolved in
Release 12.1(13)E12. (CSCea81118
Resolved FlexWAN Module Caveats in Release 12.1(13)E11
None.
Resolved FlexWAN Module Caveats in Release 12.1(13)E10
• When you configure IP precedence to ATM CoS mapping in a bundle on a FlexWAN ATM port
adapter, the precedence mapping does not work if you specify a range of precedences under a VC
in the bundle. The bundle only forwards the first precedence in the range. This problem is resolved
in Release 12.1(13)E10. (CSCea56687)
• A reload might occur if there are multiple sessions configuring an ATM interface at the same time.
This problem is resolved in Release 12.1(13)E10. (CSCdr61944)
• When you configure an ATM subinterface, it does not inherit the MTU size of the physical interface.
When you change the MTU on the physical interface, ATM subinterfaces do not inherit the changed
MTU size. This problem is resolved in Release 12.1(13)E10. (CSCea86866)
• VPN does not work on multilink PPP (MLPPP) interfaces. This problem is resolved in
Release 12.1(13)E10. (CSCea37725)
Resolved FlexWAN Module Caveats in Release 12.1(13)E9
None.
Resolved FlexWAN Module Caveats in Release 12.1(13)E8
• A FlexWAN module might reload after entering shutdown and no shutdown commands on
PA-A3-OC3, PA-A3-T3, or PA-A3-E3 interfaces. This problem is resolved in Release 12.1(13)E8.
(CSCea17496)