Datasheet

248
Release Notes for Cisco IOS Release 12.1E on the Catalyst 6500 and Cisco 7600 Supervisor Engine and MSFC
OL-2310-11
Caveats
• With a Supervisor Engine 2, (*,G) multicast entries are not programmed in hardware. This problem
is resolved in Release 12.1(13)E1. (CSCdy44937)
• The messages about the maximum number of logical interfaces are incorrect (see the “Spanning
Tree Troubleshooting” section on page 321). This problem is resolved in Release 12.1(13)E1.
(CSCdy83667)
• If a DFC fails immediately after it comes online, the system might reload and generate this error
message:
HEARTBEAT NOT_RUNNING.
This problem is most likely to occur during a system boot up or switchover. This problem is resolved
in Release 12.1(13)E1. (CSCdy72533)
• Access lists might disappear from the running-config file following a reload. This problem is
resolved in Release 12.1(13)E1. (CSCdx52334)
• The following error messages are displayed immediately after a reload:
%SYS-2-INTSCHED: 'sleep for' at level 3 -Process= "Init", ipl= 3, pid= 2 -Traceback=
6064AA94 60633C04 60FFD1C4 611867AC 6066D1CC 60596134 603D1EB0 603D30BC
603C3110 603D1C20 603BCB30601F2480 601F0460 601F09F0 601F0840 60599A60
The ip cef global configuration command and the police settings are class-map configurations and
need to have a packet identification mechanism before anything is policed (such as match protocol
http). This condition does not occur until the policy map is attached to an interface. This symptom
is observed after a reload after it had been configured with the following commands:
ip cef
policy-map test-policy
class-map test-class
match protocol http
police cir 64000 bc 16000 pir 64000 be 16000
conform-action set-clp-transmit
exceed-action set-clp-transmit
violate-action set-clp-transmit
interface e3/1
service-policy input test-policy
This problem is resolved in Release 12.1(13)E1. (CSCdw20801)
• MAC addresses with the routed MAC bit set (Routed MAC part of Layer 3 shortcut) do not age out
based on the VLAN aging timer. If the routed MAC aging time is modified from the default value,
the VLAN aging time is not used. This problem is resolved in Release 12.1(13)E1. (CSCdy33647)
• In specific oversubscription scenarios, prioritization mechanisms across the fabric do not function
properly. This problem is resolved in Release 12.1(13)E1. (CSCdy48208)
• In Release 12.1(13)E, ports with GBICs that have a bad GBIC EEPROM checksum are not allowed
to come up. The following error message is printed when this error occurs in the 12.1(13)E release:
%PM_SCP-SP-3-GBIC_BAD: GBIC integrity check on port 1/2 failed: bad key
The show interface status command displays the following output:
Router# show int status
Port Name Status Vlan Duplex Speed Type
Gi2/1 faulty routed full 1000 bad EEPROM
This problem is resolved in Release 12.1(13)E1. (CSCdy68962)