Datasheet

225
Release Notes for Cisco IOS Release 12.1E on the Catalyst 6500 and Cisco 7600 Supervisor Engine and MSFC
OL-2310-11
Caveats
Service Modules Caveats
• Open Service Modules Caveats in Release 12.1(14)E, page 225
• Resolved Service Module Caveats in Release 12.1(14)E, page 225
Open Service Modules Caveats in Release 12.1(14)E
None.
Resolved Service Module Caveats in Release 12.1(14)E
• Do not define VLANs 1002 through 1005 as secure VLANs with the firewall vlan-group command.
This problem is resolved in Release 12.1(14)E. (CSCdx88498)
• To avoid an MSFC reload, do not enter the firewall vlan-group command with VLAN IDs above
4094. This problem is resolved in Release 12.1(14)E. (CSCdy39310)
• To avoid a reload, do not enter the show firewall module module_number stat command while the
WS-SVC-FWM-1-K9 Firewall Services Module is resetting. This problem is resolved in
Release 12.1(14)E. (CSCdy53164)
OSM Caveats
• Open OSM Caveats in Release 12.1(14)E, page 225
• Resolved OSM Caveats in Release 12.1(14)E, page 225
Open OSM Caveats in Release 12.1(14)E
None.
Resolved OSM Caveats in Release 12.1(14)E
• In a system with a channelized DS3 OSM installed and more than 10,000 IP routes present, the
following error message may be displayed for the channelized DS3 OSM:
FIB-3-FIBDISABLE: Fatal error, slot/cpu 4/0: no memory
This problem is resolved in Release 12.1(14)E. (CSCdy19072, CSCdy40632)
• With Ethernet over MPLS, a problem may occur when the label switched path (LSP) for an Ethernet
over MPLS VC is changed and a new tunnel label for the new LSP is used. Instead of sending the
frame with the new tunnel label, the frame is sent with the old tunnel label. This problem is resolved
in Release 12.1(14)E. (CSCdy34983)
• In a system with a large number of Frame Relay subinterfaces configured, some subinterfaces will
not be functional after the system switches over from the active route processor to the redundant
route processor. This problem is resolved in Release 12.1(14)E. (CSCdy26531)
• If multiple OC-12-ATM OSMs with large configurations are installed in a system, you may not be
able to boot the OC-12-ATM OSMs simultaneously. This problem is resolved in Release 12.1(14)E.
(CSCdy21621, CSCdy14468)
• Hierarchical traffic shaping is not supported for Frame Relay on the channelized OSMs. This
problem is resolved in Release12.1(14)E. (CSCdx75683)