Manualshelf

Installation guide

ManualsBrandsCisco ManualsComputer equipmentExplorer 4700
71727374757677787980
4-21
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 4 Configuring Virtual Contexts
Configuring SNMP for Virtual Contexts
Step 2 Click the SNMP v2c Configuration tab.
The SNMP v2c Configuration table appears.
Step 3 Click Add to add an SNMP v2c community.
The SNMP v2c Configuration screen appears.
Note You cannot modify an existing SNMP v2c community. Instead, delete the existing SNMP v2c
community, and then add a new one.
Step 4 In the Read-Only Community field, enter the SNMP v2c community name for this context.
Valid entries are unquoted text strings with no spaces and a maximum of 32 characters.
Step 5 Do one of the following:
• Click Deploy Now to deploy this configuration on the ACE appliance.
• Click Cancel to exit this procedure without saving your entry and to return to the SNMP v2c
Community table.
• Click Add Another to save your entry and to configure another SNMP community for this virtual
context. The screen refreshes and you can enter another community name.
Related Topics
• Configuring Virtual Contexts, page 4-7
• Configuring SNMP Version 3 Users, page 4-21
• Configuring SNMP Trap Destination Hosts, page 4-23
• Configuring SNMP Notifications, page 4-25
Configuring SNMP Version 3 Users
After configuring basic SNMP information for a virtual context (see the “Configuring SNMP for Virtual
Contexts” section on page 4-19), you can configure other SNMP attributes such as SNMP version 2c
communities, SNMP version 3 users, trap destination hosts, and SNMP notification. The tabs for these
attributes appear below the SNMP configuration screen.
Use this procedure to configure SNMP version 3 users for a virtual context.
Assumption
You have configured at least one SNMP contact (see the “Configuring SNMP for Virtual Contexts”
section on page 4-19).
Procedure
Step 1 Choose Config > Virtual Contexts > context > System > SNMP.
The SNMP configuration screen appears.
Step 2 Click the SNMP v3 Configuration tab.
The SNMP v3 Configuration table appears.