Installation guide

14-18
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 14 Monitoring Your Network
Monitoring Resource Usage
Table 14-2 Context Resource Usage Fields
Field Description
Resource List of resources which can be:
• acc-connections—Number of acceleration connections
• acl-memory—Memory space allocated for ACLs
• bandwidth—Context throughput in bytes per second. The total bandwidth rate of a context
consists of the following two resource usage fields:
– throughput—Displays through-the-ACE traffic. This is a derived value (you cannot configure
it directly) and it is equal to the bandwidth rate minus the mgmt-traffic rate for the 1-Gbps and
2-Gbps licenses.
– mgmt-traffic—Displays management (to-the-ACE) traffic in bytes per second. To guarantee
a minimum amount of management traffic bandwidth, you must explicitly allocate a minimum
percentage to management traffic using the rate mgmt-traffic parameter. When you allocate a
minimum percentage of bandwidth to management traffic, the ACE subtracts that value from
the maximum available management traffic bandwidth for all contexts in the ACE.
• conc-connections—Number of simultaneous connections
• connection rate—Number of connections of any kind per second
• http-comp rate—Compression rate for HTTP-based traffic in connections per second
• inspect-conn rate—Number of application protocol inspection connections per second for FTP
and RTSP only
• mac-miss rate—To-the-ACE traffic sent to the control plane when the encapsulation is not correct
in bytes per second
• mgmt-connections—Number of management (to-the-ACE) connections
• mgmt-traffic rate—Management to-the-ACE traffic in bytes per second
• proxy-connections—Number of proxy connections
• regexp—Amount of regular expression memory
• ssl-connections rate—Number of SSL connections per second
Note The ssl-connections rate resource does not display with the ACE NPE software version
(see the “Information About the ACE No Payload Encryption Software Version” section
on page 1-2).
• sticky—Displays the resource usage for the sticky entries.
Note If a context has fewer sticky resources than the configured Allocation Minimum, the ACE
displays the Actual Minimum value that you can assign to the context.
• syslog buffer—Number of syslog buffers
• syslog rate—Number of syslog messages per second
• xlates—Number of network and port address translations entries
Current Displays the current resource usage.
Guaranteed
Available
Indicates resource units that are guaranteed to be available to each context.