Installation guide

12-71
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 12 Configuring Traffic Policies
Configuring Rules and Actions for Policy Maps
Step 9 Do the following:
• Click Deploy Now to deploy this configuration on the ACE.
• Click Cancel to exit the procedure without saving your entries and to return to the Action table.
• Click Next to deploy your entries and to configure another action.
Related Topics
• Configuring Traffic Policies, page 12-1
• Configuring Virtual Context Class Maps, page 12-8
• Configuring Virtual Context Policy Maps, page 12-34
• Configuring Rules and Actions for Policy Maps, page 12-36
Setting Policy Map Rules and Actions for RDP Server Load Balancing
Use this procedure to configure the rules and actions for RDP traffic received by the ACE.
Assumptions
• An RDP server load balancing traffic policy map has been configured.
• A class map has been defined for a class map rule if you do not want to use the class-default class
map.
Procedure
Step 1 Choose Config > Virtual Contexts > context > Expert > Policy Maps. The Policy Maps table appears.
Step 2 In the Policy Maps table, select the RDP server load balancing policy map you want to set rules and
actions for. The Rule table appears.
Step 3 In the Rule table, click Add to add a new rule, or select the rule you want to modify, and then click Edit.
The Rule screen appears.
Step 4 In the Type field, confirm that Class Map is selected.
Step 5 To use the class-default class map, check the Use Class Default check box.
The class-default class map is a reserved, well-known class map created by the ACE. You cannot delete
or modify this class. All traffic that fails to meet the other matching criteria in the named class map
belongs to the default traffic class. If none of the specified classifications matches the traffic, then the
ACE performs the action specified by the class-default class map. The class-default class map has an
implicit match any statement that enables it to match all traffic.
Step 6 To use a previously created class map:
a. Clear the Use Class Default check box.
b. In the Class Map Name field, select the class map to be used.