Installation guide

12-65
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 12 Configuring Traffic Policies
Configuring Rules and Actions for Policy Maps
Note If you selected the Insert Before option and specified True, perform the following steps to
refresh the Rule tab before adding an action for this rule:
1. Click the Rule tab to refresh the Rule table.
2. In the Rule table, select the newly added rule.
When the screen refreshes, an empty action list appears.
Step 6 In the Action table, click Add to add an entry or select an existing entry to modify, and then click Edit.
Step 7 In the Id field, accept the automatically incremented entry or assign a unique identifier for this action.
Step 8 In the Action Type field, configure actions for this rule using the information in Table 12-22.
Step 9 Do the following:
• Click Deploy Now to deploy this configuration on the ACE.
• Click Cancel to exit the procedure without saving your entries and to return to the Action table.
• Click Next to deploy your entries and to configure another action.
Related Topics
• Configuring Traffic Policies, page 12-1
• Configuring Virtual Context Class Maps, page 12-8
• Configuring Virtual Context Policy Maps, page 12-34
• Configuring Rules and Actions for Policy Maps, page 12-36
Setting Policy Map Rules and Actions for RTSP Server Load Balancing
Use this procedure to configure the rules and actions for RTSP traffic received by the ACE.
Assumptions
• An RTSP server load balancing traffic policy map has been configured.
• A class map has been defined for a class map rule if you do not want to use the class-default class
map.
Procedure
Step 1 Choose Config > Virtual Contexts > context > Expert > Policy Maps. The Policy Maps table appears.
Step 2 In the Policy Maps table, select the RTSP server load balancing policy map you want to set rules and
actions for. The Rule table appears.
Step 3 In the Rule table, click Add to add a new rule, or select the rule you want to modify, and then click Edit.
The Rule screen appears.
Step 4 In the Type field, configure rules using the information in Table 12-26.