Installation guide

12-37
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 12 Configuring Traffic Policies
Configuring Rules and Actions for Policy Maps
Setting Policy Map Rules and Actions for Layer 3/Layer 4 Network Traffic
Use this procedure to configure the rules and actions for Layer 3/Layer 4 traffic other than network
management traffic.
Assumptions
• You have configured a Layer 3/Layer 4 policy map.
• A class map has been defined if you do not want to use the class-default or class-default-v6 class
map.
Procedure
Step 1 Choose Config > Virtual Contexts > context > Expert > Policy Maps. The Policy Maps table appears.
Step 2 In the Policy Maps table, select the Layer 3/Layer 4 network traffic policy map you want to set rules and
actions for, and then select the Rule tab.
Step 3 In the Rule table, click Add to add a new rule, or select the rule you want to modify, and then click Edit.
The Rule configuration screen appears.
Step 4 In the Type field, confirm that Class Map is selected.
Step 5 In the Use Class Map field:
• For an IPv6 default class map, select the class-default radio button.
• For an IPv6 default class map, select the class-default-v6 radio button.
• For a previously created class map, go to the next step.
Server Load Balancing - HTTPS
(First-Match)
Setting Policy Map Rules and Actions for HTTPS Server
Load Balancing, page 12-58
Note The SLB HTTPS (First Match) feature does not
apply to the ACE NPE software version (see
the“Information About the ACE No Payload
Encryption Software Version” section on
page 1-2).
Server Load Balancing - RADIUS
(First-Match)
Setting Policy Map Rules and Actions for RADIUS Server
Load Balancing, page 12-63
Server Load Balancing - RDP
(First-Match)
Setting Policy Map Rules and Actions for RDP Server
Load Balancing, page 12-71
Server Load Balancing - RTSP
(First-Match)
Setting Policy Map Rules and Actions for RTSP Server
Load Balancing, page 12-65
Server Load Balancing - SIP
(First-Match)
Setting Policy Map Rules and Actions for SIP Server Load
Balancing, page 12-68
Table 12-16 Topic Reference for Policy Map Rules and Actions (continued)
Policy Map Type Topic for Setting Rules and Actions