Installation guide

12-15
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 12 Configuring Traffic Policies
Setting Match Conditions for Class Maps
Table 12-6 Management Class Map Match Conditions
Field Description
Sequence Number Enter an integer from 2 to 255 as the line number. The number entered here
does not indicate a priority or sequence for the match conditions.
Match Condition Type Select Management to confirm that this is for Layer 3/Layer 4 management
traffic.
Note To change the type of match condition, you must delete the class map
and add it again with the correct match type.
Management Protocol
Type
This field identifies the network management protocols that can be received
by the ACE appliance.
Select the allowed protocol for this match condition:
• HTTP—Specifies the Hypertext Transfer Protocol (HTTP).
• HTTPS—Specifies the Hypertext Transfer Protocol Secure (HTTPS) for
connectivity with the ACE Appliance Device Manager GUI on the ACE
appliance. Communication is performed using port 443.
• ICMP—Specifies the Internet Control Message Protocol (ICMP),
commonly referred to as ping.
• ICMPv6—Specifies the Internet Control Message Protocol version 6
(ICMPv6).
• KALAP UDP—Specifies the KeepAlive Appliance Protocol over UDP.
• SNMP—Specifies the Simple Network Management Protocol (SNMP).
• SSH—Specifies a Secure Shell (SSH) connection to the ACE appliance.
• TELNET—Specifies a Telnet connection to the ACE appliance.
• XML-HTTPS—Specifies HTTPS as the transfer protocol for sending
and receiving XML documents between the ACE appliance and a
Network Management System (NMS). Communication is performed
using port 10443.
Traffic Type
Select the type of traffic:
• Any—Indicates that any client source IP address meets the match
condition.
• Source Address—Indicates that a specific source IP address is part of
the match condition.
Source Address
This field appears if Source Address is selected for Traffic Type.
Enter the source IP address of the client in dotted-decimal notation, such as
192.168.11.1.
For ICMPv6, enter a complete IPv6 address.
Source Netmask
This field appears if Source Address is selected for Traffic Type.
Select the subnet mask for the source IP address.
Source Prefix-length
This field appears if ICMPv6 is selected for the Management Protocol Type
and Source Address is selected for Traffic Type.
Enter the prefix length for the source IPv6 address.