Installation guide

12-14
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 12 Configuring Traffic Policies
Setting Match Conditions for Class Maps
Step 6 Do the following:
• Click Deploy Now to deploy this configuration on the ACE appliance and to return to the Match
Condition table.
Note If you click Deploy Now, the ACE appliance drops the traffic and then restarts it, even if
you have not made changes. If you have not altered existing match conditions, click Cancel
instead of Deploy Now to ensure uninterrupted traffic.
• Click Cancel to exit the procedure without saving your entries and to return to the Match Condition
table.
• Click Next to save your entries and to configure additional match conditions.
Related Topics
• Configuring Traffic Policies, page 12-1
• Setting Match Conditions for Layer 3/Layer 4 Management Traffic Class Maps, page 12-14
• Setting Match Conditions for Layer 7 Server Load-Balancing Class Maps, page 12-16
• Configuring Virtual Context Policy Maps, page 12-34
• Configuring Virtual Context Class Maps, page 12-8
Setting Match Conditions for Layer 3/Layer 4 Management Traffic Class
Maps
Use this procedure to identify the network management protocols that can be received by the ACE
appliance.
Assumption
You have configured a network management class map and want to establish the match conditions.
Procedure
Step 1 Choose Config > Virtual Contexts > context > Expert > Class Maps. The Class Maps table appears.
Step 2 In the Class Maps table, select the Layer 3/Layer 4 management class map you want to set match
conditions for. You can select multiple class maps (hold down the Shift key while selecting entries) and
apply common match conditions to them.
Step 3 In the Match Condition table, click Add to add match criteria, or select the match conditions you want
to modify, and then click Edit. The Match Condition configuration screen appears.
Step 4 Enter the match conditions (see Table 12-6).