Installation guide

11-22
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 11 Configuring High Availability
Configuring Peer Host Tracking Probes
Deleting Host Tracking Probes
Use this procedure to remove a high availability host tracking probe.
Procedure
Step 1 Choose Config > Virtual Contexts > HA Tracking And Failure Detection > Hosts. The Track Host
table appears.
Step 2 Select the tracking process you want to modify, and then select the Track Host Probe tab. The Track Host
Probe table appears.
Step 3 In the Track Host table, select the probe you want to remove, and then click Delete. The probe is deleted
and the Track Host Probe table refreshes without the deleted probe.
Related Topics
• Configuring Peer Host Tracking Probes, page 11-22
• Configuring High Availability Peers, page 11-8
• Configuring ACE High Availability Groups, page 11-11
• Tracking VLAN Interfaces for High Availability, page 11-19
Configuring Peer Host Tracking Probes
Use this procedure to configure probes on the standby member of a high availability group to track the
health of the gateway or host.
Assumptions
• At least one host tracking process for high availability has been configured (see Tracking Hosts for
High Availability, page 11-20.)
• At least one health monitoring probe has been configured (see Configuring Health Monitoring for
Real Servers, page 6-41).
Procedure
Step 1 Choose Config > Virtual Contexts > HA Tracking And Failure Detection > Hosts. The Track Host
table appears.
Step 2 Select the tracking process you want to modify, and then select the Peer Track Host Probe tab. The Peer
Track Host Probes table appears.
Step 3 In the Peer Track Host Probes table, click Add to add a peer host tracking probe, or select an existing
peer host tracking probe, and then click Edit to modify it. The Peer Track Host Probes configuration
screen appears.
Step 4 In the Probe Name field, select the name of the probe to be used for the peer host tracking process.