Installation guide

10-19
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 10 Configuring Network Access
Configuring Virtual Context VLAN Interfaces
Output Access Group From the Available list, double-click an ACL name for the ACL output
access group that is associated with this VLAN interface or use the right
arrow to move it to the Selected list. Any ACL group listed in the
Selected list specifies that this access group is to be applied to the
outbound direction of the interface; that is, all traffic sent by this
interface.
Static ARP Entry (IP/MAC
Address)
For the Static ARP entry, do the following:
a. In the ARP IP Address field, enter the IP address. This field accepts
IPv4 addresses only.
b. In the ARP MAC Address field, enter the hardware MAC address for
the ARP table entry (for example, 00.02.9a.3b.94.d9).
c. When completed, use the right arrow to move the static ARP entry
to the list box. Use the Up and Down arrows to choose the priority
of the static ARP entry in the list box. These arrows modify the
order of the static ARPs for new VLANs only; they do not modify
the static ARP order when editing an existing policy map.
DHCP Relay Configuration Enter the IPv4 address of the DHCP server to which the DHCP relay
agent is to forward client requests. Enter the IP address in dotted-decimal
notation, such as 192.168.11.2.
IPv6 Forward Interface
VLAN
Enter the VLAN to forward all received client requests with destination
being the IPv6 DHCP address configured in the IPv6 DHCP Relay
Configuration field.
IPv6 DHCP Relay
Configuration
Enter the IPv6 address for the DHCP server where the DHCP relay
agent forwards client requests.
Select the VLAN when the server address is a link local address.
Note When you enter a DHCPv6 server global IPv6 address, a VLAN
is not required.
Managed-Config Check the check box to indicate that the interface use the stateful
autoconfiguration mechanism to configure IPv6 addresses.
Clear the check box to indicate that the interface does not use the
stateful autoconfiguration mechanism to configure IPv6 addresses.
Other-Config Check the check box to indicate that the interface use the stateful
autoconfiguration mechanism to configure parameters other than IPv6
addresses.
Clear the check box to indicate that the interface does not use the
stateful autoconfiguration mechanism to configure parameters other
than IPv6 addresses.
Table 10-3 VLAN Interface Attributes (continued)
Field Description