Installation guide

10-6
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 10 Configuring Network Access
Configuring Gigabit Ethernet Interfaces
Step 2 Select an existing Gigabit Ethernet interface, and then click Edit to modify it.
Step 3 Enter the Gigabit Ethernet physical interface attributes (see Table 10-2).
Table 10-2 Gigabit Ethernet Physical Interface Attributes
Field Description
Interface Name Name of the Gigabit interface, which is the slot_number/port_number where
slot_number is the physical slot on the ACE for the specified port, and
port_number is the physical Ethernet data port on the ACE for the specified
port.
Description Enter a brief description for this interface.
Admin Status Indicate whether you want the interface to be Up or Down.
Speed Specifies the port speed, which can be
• Auto—Autonegotiate with other devices
• 10 Mbps
• 100 Mbps
• 1000 Mbps
Duplex Specifies an interface duplex mode, which can be:
• Auto—Resets the specified Ethernet port to automatically negotiate port
speed and duplex of incoming signals. This is the default setting.
• Half—Configures the specified Ethernet port for half-duplex operation.
A half-duplex setting ensures that data only travels in one direction at any
given time.
• Full—Configures the specified Ethernet port for full-duplex operation,
which allows data to travel in both directions at the same time.