Installation guide

9-22
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 9 Configuring SSL
Configuring SSL Parameter Maps
Step 12 In the Parameter Map Cipher table, click Add to add a cipher, or select an existing cipher, and then click
Edit. The Parameter Map Cipher configuration screen appears.
Enter the information in Table 9-11.
Step 13 In the Parameter Map Cipher table, do one of the following:
• Deploy Now to deploy this configuration on the ACE appliance.
• Cancel to exit the procedure without saving your entries and to return to the Parameter Map Cipher
table.
• Next to save your entries and to add another entry to the Parameter Map Cipher table.
Step 14 Click the Redirect Authentication Failure tab and click Add to add a redirect or choose an existing
redirect, and click Edit.
Enter the information in Table 9-12.
Note The Redirect Authentication Failure feature is only for SSL termination configurations in which
the ACE performs client authentication. The ACE ignores these attributes if you configure them
for an SSL initiation configuration.
Table 9-11 SSL Parameter Map Cipher Configuration Attributes
Field Description
Cipher Name Cipher to use.
For more information on the SSL cipher suites that ACE supports, see SSL Guide, Cisco ACE
Application Control Engine.
Cipher Priority Priority that you want to assign to this cipher suite. The priority indicates the cipher’s preference
for use.
Valid entries are from 1 to 10 with 1 indicating the least preferred and 10 indicating the most
preferred. When determining which cipher suite to use, the ACE chooses the cipher suite with the
highest priority.