Installation guide

6-8
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 6 Configuring Real Servers and Server Farms
Configuring Real Servers
Step 4 Do the following:
• Click Deploy Now to deploy this configuration on the ACE appliance.
• Click Cancel to exit the procedure without saving your entries and to return to the Real Servers
table.
• Click the Add another icon to save your entries and to configure another real server.
Step 5 To display statistics and status information for an existing real server, choose a real server from the Real
Servers table, and then click Details. The show rserver name detail CLI command output appears. See
the “Displaying Real Server Statistics and Status Information” section on page 6-8 for details.
Related Topics
• Configuring Health Monitoring for Real Servers, page 6-41
• Configuring Server Farms, page 6-18
• Configuring Sticky Groups, page 7-11
Displaying Real Server Statistics and Status Information
You can display statistics and status information for a particular real server.
Procedure
Step 1 Choose Config > Virtual Contexts > context > Load Balancing > Real Servers.
The Real Servers table appears.
Step 2 In the Real Servers table, choose a real server from the Real Servers table, and click Details.
The show rserver name detail CLI command output appears. For details on the displayed output fields,
see the Server Load-Balancing Guide, Cisco ACE Application Control Engine, Chapter 2, “Configuring
Real Servers and Server Farms.”
Step 3 Click Update Details to refresh the output for the show rserver name detail CLI command. The new
information appears in a separate panel with a new timestamp; both the old and the new real server
statistics and status information appear side-by-side to avoid overwriting the last updated information.
Rate Bandwidth The bandwidth rate is the number of bytes per second and applies to the
network traffic exchanged between the ACE and the real server in both
directions.
Specify the real server bandwidth limit in bytes per second. Valid entries are
integers from 1 to 300000000.
Rate Connection The connection rate is the number of connections per second received by the
ACE and applies only to new connections destined to a real server.
Specify the limit for connections per second. Valid entries are integers from
1 to 350000.
Table 6-1 Real Server Attributes (continued)
Field Description