Installation guide

5-43
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 5 Configuring Virtual Servers
Configuring Virtual Servers
Probes (Cont.) • Probe Expect Status—To configure probe expect status for an FTP, HTTP, HTTPS, RTSP, SIP-TCP,
SIP-UDP, or SMTP probe, in the Probe Expect Status field enter the following information:
– To configure a single expect status code, enter the minimum expect status code for this probe
followed by the same expect status code that you entered as the minimum. Valid entries are integers
from 0 to 999.
– To configure a range of expect status codes, enter the lower limit of the range of status codes
followed by the upper limit of the range of status codes. The maximum expect status code must be
greater than or equal to the value specified for the minimum expect status code. Valid entries are
integers from 0 to 999.
• SNMP OID Table—To configure the SNMP OID for an SNMP probe, see the “Configuring an OID for
SNMP Probes” section on page 6-68.
After you add a probe, you can modify the attributes for a health probe from the Health Monitoring table
(Config > Virtual Contexts > context > Load Balancing > Health Monitoring) as described in the
“Configuring Health Monitoring for Real Servers” section on page 6-41. You can also delete an existing
health probe from the Health Monitoring table.
Table 5-11 New Server Farm Attributes (continued)
Field Description