Installation guide

4-75
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 4 Configuring Virtual Contexts
Configuring Object Groups
Step 5 Do one of the following:
• Click Deploy Now to immediately deploy this configuration. This option appears for virtual
contexts.
• Click Cancel to exit this procedure without saving your entries.
• Click Next to deploy your entries and to add another entry to the TCP/UDP Service Parameters
table.
Related Topics
• Configuring Object Groups, page 4-70
• Configuring IP Addresses for Object Groups, page 4-71
• Configuring Subnet Objects for Object Groups, page 4-72
• Configuring Protocols for Object Groups, page 4-73
• Configuring ICMP Service Parameters for an Object Group, page 4-76
Lower Destination Port This field appears if you select Range in the Destination Port Operator field.
Enter the number that is the beginning value for a range of services for this service object. Valid
entries are integers from 0 to 65535. The number in this field must be less than the number entered
in the Upper Destination Port field.
Upper Destination Port This field appears if you select Range in the Destination Port Operator field.
Enter the number that is the ending value for a range of services for this service object. Valid
entries are integers from 0 to 65535. The number in this field must be greater than the number
entered in the Lower Destination Port field.
Table 4-21 TCP and UDP Service Parameters (continued)
Field Description