Installation guide

4-74
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 4 Configuring Virtual Contexts
Configuring Object Groups
Table 4-21 TCP and UDP Service Parameters
Field Description
Protocol Select the protocol for this service object:
• TCP—TCP is the protocol for this service object.
• UDP—UDP is the protocol for this service object.
• TCP And UDP—Both TCP and UDP are the protocols for this service object.
Source Port Operator Select the operand to use when comparing source port numbers for this service object:
• Equal To—The source port must be the same as the number in the Source Port field.
• Greater Than—The source port must be greater than the number in the Source Port field.
• Less Than—The source port must be less than the number in the Source Port field.
• Not Equal To—The source port must not equal the number in the Source Port field.
• Range—The source port must be within the range of ports specified by the Lower Source Port
field and the Upper Source Port field.
Source Port This field appears if you select Equal To, Greater Than, Less Than, or Not Equal To in the Source
Port Operator field.
Enter the source port name or number for this service object.
Lower Source Port This field appears if you select Range in the Source Port Operator field.
Enter the number that is the beginning value for a range of services for this service object. Valid
entries are integers from 1 to 65535. The number in this field must be less than the number entered
in the Upper Source Port field.
Upper Source Port This field appears if you select Range in the Source Port Operator field.
Enter the number that is the ending value for a range of services for this service object. Valid
entries are integers from 2 to 65535. The number in this field must be greater than the number
entered in the Lower Source Port field.
Destination Port
Operator
Choose the operand to use when comparing destination port numbers:
• Equal To—The destination port must be the same as the number in the Destination Port field.
• Greater Than—The destination port must be greater than the number in the Destination Port
field.
• Less Than—The destination port must be less than the number in the Destination Port field.
• Not Equal To—The destination port must not equal the number in the Destination Port field.
• Range—The destination port must be within the range of ports specified by the Lower
Destination Port field and the Upper Destination Port field.
Destination Port This field appears if you select Equal To, Greater Than, Less Than, or Not Equal To in the
Destination Port Operator field.
Enter the destination port name or number for this service object.