Installation guide

4-71
Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance
OL-26645-02
Chapter 4 Configuring Virtual Contexts
Configuring Object Groups
• Click Cancel to exit without saving your entries and to return to the Object Groups table.
• Click Next to deploy your entries and to add another entry to the Object Groups table.
Step 7 Configure objects for the object group.
For network-type object groups, options include:
• Configuring IP Addresses for Object Groups, page 4-71
• Configuring Subnet Objects for Object Groups, page 4-72
For service-type object groups, options include:
• Configuring Protocols for Object Groups, page 4-73
• Configuring TCP/UDP Service Parameters for Object Groups, page 4-73
• Configuring ICMP Service Parameters for an Object Group, page 4-76
Related Topics
• Configuring Virtual Context Expert Options, page 4-79
• Creating ACLs, page 4-59
• Setting Extended ACL Attributes, page 4-61
• Resequencing Extended ACLs, page 4-66
Configuring IP Addresses for Object Groups
Use this procedure to specify host IP addresses for network-type object groups.
Procedure
Step 1 Choose Config > Virtual Contexts > context > Security > Object Groups.
The Object Groups table appears, listing existing object groups.
Step 2 Choose the object group you want to configure host IP addresses for and then click the Host Setting For
Object Group tab.
The Host Setting For Object Group table appears.
Step 3 Click Add to add an entry to this table.
Step 4 Choose one of the following:
• IPv4—A host with an IPv4 IP address. In the IPv4 Address field, enter the IP address of a host to
include in this group.
• IPv6—A host with an IPv6 IP address. In the IPv6 Address field, enter the IP address of a host to
include in this group.
Step 5 Do one of the following:
• Click Deploy Now to immediately deploy this configuration. This option appears for virtual
contexts.
• Click Cancel to exit this procedure without saving your entries.