Specifications

3-25
Cisco Unified Communications Manager Managed Services Guide, Release 8.0(1)
OL-20105-01
Chapter 3 Managing and Monitoring the Health of Cisco Unified Communications Manager Systems
RTMT Monitoring of Cisco Unified CM System Health
Syslog Messages
Syslog messages can be viewed using RTMT syslog viewer as shown in Figure 3-11.
Figure 3-11 Syslog Viewer
To send syslog traps to a remote server for the CISCO-SYSLOG-MIB follow these steps:
Step 1 Setup Trap (Notification) destination in Cisco Unified Serviceability SNMP window.
Step 2 Enable trap generation in CISCO-SYSLOG-MIB.
Step 3 Set the appropriate SysLog level in CISCO-SYSLOG-MIB.
If syslog traps are not being generated for some Cisco Unified CM service alarms, check the RTMT
syslog viewer to see if the alarms are shown there. If not, adjust alarm configuration setting to send
alarms to local syslog.
Syslogs generated due to hardware failures have an event severity of 4 or higher and contain one of the
following patterns:
• *cma*[???]:*
• *cma*[????]:*
• *cma*[?????]:*
• *hp*[???]:*
• *hp*[????]:*
• *hp*[?????]:*
You can search for the above patterns to find hardware failure events in syslog.