Specifications

6-211
Cisco Unified Communications Manager Managed Services Guide, Release 8.0(1)
OL-20105-01
Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages
Warning-Level Alarms
Enum Definitions for IPAddrAttributes
Enum Definitions for IPV6AddrAttributes
Recommended Action
Actions to take vary depending on the reason specified for the device unregistration. If the reason is
ConfigurationMismatch, go to the Device Configuration page in Cisco Unified CM Administration,
make a change to the Description field for this device, click Save, then reset the device. In the case of a
network connectivity or loss of KeepAlives problem, use network diagnostic tools and the Cisco Unified
CM Reporting tool to fix any reported network or Unified CM system errors. In the case of a device
rehoming to the primary Unified CM node, watch for a successful registration of the device on the
primary node. In the case of a duplicate registration request, it may be a non-malicious occurrence due
to timing of a device registering and unregistering; if duplicate registration requests continue or if the
same device has different IP addresses, confirm the IP address on the physical device itself by checking
the settings on the device (settings button). If unregistration of this device was expected, no action is
required. Also, refer to the reason code descriptions for recommended actions.
16 DuplicateRegistration - Cisco Unified CM detected that the device attempted to register
to 2 nodes at the same time. Cisco Unified CM initiated a restart to the phone to force it
to re-home to a single node. No action necessary, the device will re-register
automatically.
17 CallManagerApplyConfig - An ApplyConfig command was invoked from Unified CM
Administration resulting in an unregistration. No action necessary, the device will
re-register automatically.
18 DeviceNoResponse - The device did not respond to a reset or restart notification, so it is
being forcefully reset. If the device does not re-register within 5 minutes, confirm it is
powered-up and confirm network connectivity between the device and Cisco Unified
CM.
Code Reason
0 Unknown—The device has not indicated what this IPv4 address is used for.
1 Administrative only—The device has indicated that this IPv4 address is used for
administrative communication (web interface) only.
2 Signal only—The device has indicated that this IPv4 address is used for control
signaling only.
3 Administrative and signal—The device has indicated that this IPv4 address is
used for administrative communication (web interface) and control signaling.
Code Reason
0 Unknown - The device has not indicated what this IPv6 address is used for
1 Administrative only - The device has indicated that this IPv6 address is used for
administrative communication (web interface) only.
2 Signal only - The device has indicated that this IPv6 address is used for control
signaling only.
3 Administrative and signal - The device has indicated that this IPv6 address is
used for administrative communication (web interface) and control signaling.