Specifications

6-207
Cisco Unified Communications Manager Managed Services Guide, Release 8.0(1)
OL-20105-01
Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages
Warning-Level Alarms
Enum Definitions for IPV6AddrAttributes
Recommended Action
In the Cisco Unified Reporting tool, check the Active Services section of the Unified CM Cluster
Overview report to confirm that any failover/fallback scenarios have completed. Confirm that
auto-registration is enabled if the phone attempting to connect is set to auto-register, or locate the phone
that is attempting to auto-register if auto-registration has been intentionally disabled. Check the device
indicated in this alarm and confirm that the device registration details in Cisco Unified CM
Administration are accurate. Also, refer to the reason code definitions for recommended actions. No
action is required if this event was issued as a result of a normal device rehome.
DeviceUnregistered
A device that has previously registered with Cisco CallManager has unregistered. In cases of normal
unregistration with reason code 'CallManagerReset', 'CallManagerRestart', or 'DeviceInitiatedReset', the
severity of this alarm is lowered to INFORMATIONAL. A device can unregister for many reasons, both
intentional, such as manually resetting the device after a configuration change, or unintentional, such as
loss of network connectivity. Other causes for this alarm could include a phone being registered to a
secondary node and then the primary node come back online, causing the phone to rehome to the primary
Unified CM node or lack of a KeepAlive being returned from the Unified CM node to which this device
was registered. Unregistration also occurs if Unified CM receives a duplicate registration request for this
same device.
Code Reason
0 Unknown—The device has not indicated what this IPv6 address is used for.
1 Administrative only—The device has indicated that this IPv6 address is used for
administrative communication (web interface) only.
2 Signal only—The device has indicated that this IPv6 address is used for control
signaling only.
3 Administrative and signal—The device has indicated that this IPv6 address is
used for administrative communication (web interface) and control signaling.
History
Cisco Unified Communications
Release Action
8.0(1) • Severity changed from Error to Warning.
• Following information is updated:
– Enum Definitions for DeviceType
– Enum Definition
– Enum Definitions for IPAddrAttributes
– Enum Definitions for IPV6AddrAttributes
7.1 Parameters added: IPV6Address,IPAddrAttributes, and
IPV6AddrAttributes.