Specifications

6-121
Cisco Unified Communications Manager Managed Services Guide, Release 8.0(1)
OL-20105-01
Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages
Error-Level Alarms
474 **INFO LEVEL** SAF_UNREGISTERED - Unified CM attempted to
publish or subscribe to the SAF Forwarder, but Unified CM is not registered
with SAF Forwarder. Unified CM will automatically reregister with the SAF
Forwarder before attempting to publish or subscribe. This alarm is for infor
-
mational purposes only; no action is required.
475 **INFO LEVEL** SAF_BAD_FILTER - Unified CM attempted to
subscribe to the SAF Forwarder with a filter that does not match any of the
SAF Forwarder's current filters. Unified CM will resend the subscribe
message with the appropriate filter value. This alarm is for informational
purposes only; no action is required.
476 SAF_UNKNOWN_SUBSCRIPTION - Unified CM sent a subscribe or un-
subscribe message to the SAF Forwarder but the message contained a Service
ID that was not familiar to the SAF Forwarder. Without a recognized Service
ID, Unified CM cannot subscribe to the SAF Forwarder. Recommended
action is to contact the Cisco Technical Assistance Center (TAC).
477 **INFO LEVEL** SAF_ALREADY_REGISTERED - Unified CM
attempted to register with the SAF Forwarder but SAF Forwarder indicates
that Unified CM is already registered. Unified CM will close and reopen the
TCP connection and send a new register request without a client handle to
SAF Forwarder. This alarm is for informational purposes only; no action is
required.
478 SAF_UNSUPPORTED_PROTOCOL_VERSION - Unified CM attempted to
register with the SAF Forwarder using a SAF protocol version number that
is greater than the protocol version number supported by the SAF Forwarder.
Issue a show version command on the SAF Forwarder CLI to determine the
SAF Forwarder protocol version; refer to the information in this alarm for the
SAF protocol version number. If the versions do not match, check the Cisco
Unified Communications Manager Software Compatibility Matrix (available
on Cisco.com) to determine whether the SAF protocol version number that is
in use on this Unified CM is compatible with the SAF Forwarder protocol
version. If it is not, upgrade the lower-versioned component so that both
Unified CM and the SAF Forwarder use the same, compatible version.
479 SAF_UNKNOWN_AS - Unified CM attempted to register to the SAF
Forwarder but the registration message contained a Client Label that was not
familiar to the Autonomous System (AS) on the SAF Forwarder router. Rec
-
ommended action is to issue the appropriate CLI commands on the SAF
Forwarder to associate the Client Label with the autonomous system on the
router (refer to the Configuration Guide for the router) and configure the
same Client Label in the Client Label field on the SAF Forwarder Configu
-
ration window in Cisco Unified CM Administration and click Save. When
the Client Label is saved in Cisco Unified CM Administration, Unified CM
automatically sends a new registration request to the SAF Forwarder with the
updated Client Label information.
Value Definition