Specifications
Table Of Contents
- CiscoIPPhone Expansion Module 7914
- 1 Introducing the CiscoIPPhone Expansion Module7914
- 2 Installing the ExpansionModule 7914
- 3 Features of the ExpansionModule7914
- 4 Using the ExpansionModule7914
- 5 Troubleshooting the ExpansionModule7914
- 6 Technical Specifications for the ExpansionModule7914
- 7 Where to Find More Information
- 8 Cisco Product Security Overview
- 9 Obtaining Technical Assistance
- 10 Cisco One-Year Limited Hardware Warranty Terms
- CiscoIPPhone7914 ExpansionModule
6
Warning
The power supply must be placed indoors.
Caution Only use the specified Cisco-approved power
supply on this product.
2 Installing the Expansion Module
7914
Note To ensure a successful installation of the
Expansion Module 7914, make sure you have read the
entire “Before You Begin” section on page 2.
To install the Expansion Module 7914, perform the following
steps.
1. Remove the Footstand from the Cisco IP Phone.
2. Connect the Support Bar to the Cisco IP Phone.
3. Connect the Expansion Module 7914 to the Support Bar.
4. Connect the Interface Cable.
5. Connect the Power Supply.
6. Connect the Footstand.
7. Connect a Laptop Cable Lock (optional).
Refer to the detailed instructions and corresponding
illustrations that follow for each of these high-level steps.
Caution To ensure a successful installation, verify with your
system administrator that your phone is ready for
the Expansion Module 7914 and that
Cisco CallManager is installed and configured for
the Expansion Module 7914. Make sure that you
have all of the parts that you need (see the “Before
You Begin” section on page 2).