User guide

www.cisco.com
If the Touch controller is used in environments with
considerable amounts of electromagnetic noise
present, you may experience an appearance of false
signals—as if someone tapped the Touch controller
when nobody obviously did so.
To cope with this you may set the EMC Resilience
Mode to On. You must then press and hold for a little
while, rather than just tap, in order to make the system
aware of your tapping. This will avoid the appearance
of false signals.
As long as the system is used in environments without
consideable amounts of electromagnetic noise, the
setting should be set to O (as shown).
Administrator Settings—EMC Resilience Mode
39
Cisco TelePresence System EX90 User guide
D14724.04 User guide EX90, TC4.1, February 2010.
All contents are Copyright © 2010–2011 Cisco Systems, Inc. All rights reserved.
Contents
Contact us
Introduction
Connecting the EX90
Using the EX90
The settings
Web interface
The settings