User guide

www.cisco.com

Outside a call, you may have the unit enter standby mode by touching the

Power button on the main unit (the screen). The Standby dialog is displayed

and the unit enters standby immediately. This does not work when you are in a

call.

Outside a call, press the Power button until the Shutdown progress bar is lled

completely.

Release the button and the unit will go in shutdown in just a few seconds.

To revert to the factory default settings, do as follows:

1. Disconnect the power cord.

2. Reconnect the power cord—a green light will illuminate shortly after.

3. Press the Power button as soon as the green light appears. Keep it de-

pressed for 15 seconds or so, until the green light starts ashing.

4. Release the button and press twice within 2 seconds. All settings will now

revert to factory default settings.

Setting the EX90 in standby

Shutting down the EX90

Reverting to factory default settings

Tap as shown to

wake up the system

from standby.

To start the system again,

press the Power button

until the LED illuminates

(green light).

Cisco TelePresence System EX90 User guide

D14724.04 User guide EX90, TC4.1, February 2010.

Contents

Introduction

Connecting the EX90

Using the EX90

The settings

Web interface

The settings