Operating instructions

Chapter 5. Cisco Systems IGESM management and user orientation 47
Adding to a cluster
To add additional devices to the cluster, perform the following steps:
1. Choose Cluster
→ Add To Cluster from the menu bar (Figure 5-30).
Figure 5-30 Cisco Cluster Management Suite window
2. In the Current Candidates list (Figure 5-31), select the switches that you want to add to the
cluster. To select all the switches in the list, click Select All.
Figure 5-31 Add To Cluster window
3. Click Add to move your selections to the Add To Cluster list.
To remove switches from this list, select the switches and click Remove. To remove all
switches from the list, click Select All and then Remove.
4. In the Password field, enter a password if the switch was configured with one.
5. Click OK. If a password is required and you did not enter one, you will be prompted to
enter it.
Note: If you requested this window from a pop-up menu, the devices that you selected
will be in the Add To Cluster list when the window opens.
Note: If member switches will have different passwords, you must add them in groups
that have the same password.