Operating instructions

168 Cisco Systems Intelligent Gigabit Ethernet Switch Module
Table 7-16 Configuring CIGESM1
Description and comments Actions via IOS CLI for CIGEMS1 Actions via CMS for CIGEMS1
Step 3.1.1: Configure desired
VLANs for CIGESM1
.
Create VLANs 10, 15, 30, 35, 40,
45, and 50 (only named VLAN 10
and 15 for this demonstration).
Perform the following from the enable
mode:
config t
vlan 10
name Web
vlan 15
name User
vlan 30,35,40,45,50
Note no spaces between the VLAN
numbers and the commas.
Perform the following from the CMS
interface:
1. In the top toolbar, click VLAN →
VLAN.
2. Click the Configure VLANs tab.
3. Click Create.
4. Enter 10 in the VLAN ID field.
5. Enter Web in the VLAN Name field.
6. Click OK.
7. Click Create.
8. Enter 15 in the VLAN ID field.
9. Enter User in the VLAN Name field.
10. Click OK.
11. Click Create.
12. Enter 30 in the VLAN ID field (leave
the name field defaulted).
13. Click OK.
14. Repeat the previous three steps to
create VLANs 35, 40, 45, and 50.
15. Click Apply.
16. Click Refresh to view the newly
created VLANs.
Step 3.1.2:
Configure Link
Aggregation toward 6500-1
.
This example makes use of LACP
to form the aggregation.
Ports g0/17 and g0/18 will be
going to 6500-1.
int range g0/17 - 18
description To-6500-1
channel-group 1 mode active
This creates a logical interface named
Port-Channel1 and places the
interfaces g0/17 and g0/18 into it.
1. In the top toolbar, click Port →
EtherChannels.
2. Click Create.
3. Select the check boxes next to
ports Gi0/17 and Gi0/18.
4. Enter 1 in the Group [1-6] field to
select the port channel to use.
5. Click OK.
6. Click Apply or OK.