Installation guide

Installing the Router 2-5
Connecting to an AUI Ethernet
Step 4 Check the following LEDs:
• The transceiver power LED (the location depends on model)—On when
power is supplied to the transceiver through the router.
• The LAN ACT LED (front panel)—Blinks when there is traffic on the
Ethernet LAN.
Figure 2-2 AUI Port to Ethernet Transceiver Connection (Cisco 1601 Shown)
DO NOT INSTALL ANY WAN
MODULE WITH POWER ON
H7197
Router
Ethernet AUI port
(DB-15)
(with jackscrews
or slide-latch)
BNC connector
To thin
Ethernet
network
To thin
Ethernet
network
Ethernet
transceiver
Transceiver
adapter cable