Specifications

3-430
Cisco Wide Area Application Services Command Reference
OL-11817-01
Chapter 3 CLI Commands
(config-if) no
(config-if) no
To negate a Gigabit Ethernet interface configuration command or set its defaults, use the following no
command from GigabitEthernet interface configuration mode.
no [autosense | bandwidth {10 | 100 | 1000} | cdp enable | channel-group {1 | 2} | description
text | fullduplex | halfduplex | ip {access-group {acl-num
| acl_name} {in | out} | address
{ip_address netmask [secondary] | dhcp [client-id id hostname name | hostname name
client-id id]}} | mtu mtusize
| shutdown | standby grpnumber [priority priority]]
To negate an InlineGroup interface configuration command or set its defaults, use the following no
commands from the InlineGroup interface configuration mode.
no [failover timeout {1 | 3 | 5} | inline [vlan {all | native | vlan_list}] | shutdown]
To negate an InlinePort interface configuration command or set its defaults, use the following no
commands from the InlinePort interface configuration mode.
no [autosense | bandwidth {10 | 100 | 1000} | full-duplex | half-duplex]
To negate a PortChannel interface configuration command or set its defaults, use the following no
commands from the Port Channel interface configuration mode.
no [description text | ip {access-group {acl-num | acl_name} {in | out} | address ip-address
netmask} | shutdown]
Syntax Description The command options vary. For more information on the syntax description, see the “(config) interface”
command.
Command Defaults No default behavior or values
Command Modes interface configuration
Device Modes application-accelerator
central-manager
Usage Guidelines The command options for the no interface configuration command vary depending on the current
interface configuration mode. For example, if you are in Gigabit interface configuration mode, there are
11 options for the no command.
WAE(config)# interface GigabitEthernet 2/0
WAE(config-if)# no ?
autosense Interface autosense
bandwidth Interface bandwidth
cdp Cisco Discovery Protocol Interface Config commands
channel-group Configure EtherChannel group
description Interface specific description
full-duplex Interface fullduplex
half-duplex Interface halfduplex