Specifications

3-402
Cisco Wide Area Application Services Command Reference
OL-11817-01
Chapter 3 CLI Commands
(config) wccp access-list
The following example shows sample output from the show wccp gre EXEC command when WCCP
access lists are defined on the WAE:
WAE# show wccp gre
Transparent GRE packets received: 366
Transparent non-GRE packets received: 0
Transparent non-GRE packets passed through: 0
Total packets accepted: 337
Invalid packets received: 0
Packets received with invalid service: 0
Packets received on a disabled service: 0
Packets received too small: 0
Packets dropped due to zero TTL: 0
Packets dropped due to bad buckets: 0
Packets dropped due to no redirect address: 0
Packets dropped due to loopback redirect: 0
Connections bypassed due to load: 0
Packets sent back to router: 0
Packets sent to another CE: 0
GRE fragments redirected: 0
Packets failed GRE encapsulation: 0
Packets dropped due to invalid fwd method: 0
Packets dropped due to insufficient memory: 0
Packets bypassed, no conn at all: 0
Packets bypassed, no pending connection: 0
Packets due to clean wccp shutdown: 0
Packets bypassed due to bypass-list lookup: 0
Packets received with client IP addresses: 0
Conditionally Accepted connections: 0
Conditionally Bypassed connections: 0
L2 Bypass packets destined for loopback: 0
Packets w/WCCP GRE received too small: 0
Packets dropped due to IP access-list deny: 29
L2 Packets fragmented for bypass: 0
Related Commands show ip access-list
show wccp