Specifications

3-364

Cisco Wide Area Application Services Command Reference

OL-11817-01

Chapter 3 CLI Commands

(config) snmp-server mib

To configure persistence for the SNMP Event MIB, use the snmp-server mib global configuration

command. To disable the Event MIB, use the no form of this command.

snmp-server mib persist event

Syntax Description

Defaults No default behavior or values

Command Modes global configuration

Device Modes application-accelerator

central-manager

Usage Guidelines The Event MIB can set the threshold on any MIB variables supported by WAAS software and store the

threshold permanently on disk.

The WAAS software implementation of SNMP supports the following MIBs:

• MIB-II

• ENTITY-MIB

• EVENT-MIB

• HOST-RESOURCES-MIB

• CISCO-CONTENT-ENGINE-MIB (partial)

• CISCO-ENTITY-ASSET-MIB

• CISCO-CONFIG-MAN-MIB

• CISCO-CDP-MIB

• SNMPv2

• ACTONA-ACTASTORE-MIB

Note In WAAS software, there are six generic alarm traps in the CISCO-CONTENT-ENGINE-MIB for SNMP

and Node Health Manager integration.

In WAAS software, you can use IP ACLs to control SNMP access on a WAAS device.

persist Configures MIB persistence.

event Enables MIB persistence for the Event MIB.