Specifications

3-362
Cisco Wide Area Application Services Command Reference
OL-11817-01
Chapter 3 CLI Commands
(config) snmp-server host
Usage Guidelines If you do not enter an snmp-server host command, no traps are sent. To configure the WAAS device to
send SNMP traps, you must enter at least one snmp-server host command. To enable multiple hosts,
you must issue a separate snmp-server host command for each host. The maximum number of
snmp-server host commands is four.
When multiple snmp-server host commands are given for the same host, the community string in the
last command is used.
The snmp-server host command is used in conjunction with the snmp-server enable traps command
to enable SNMP traps.
In addition, SNMP must be enabled with the snmp-server community command.
Examples The following example sends the SNMP traps defined in RFC 1157 to the host specified by the
IP
address 172.16.2.160. The community string is comaccess:
WAE(config)# snmp-server enable traps
WAE(config)# snmp-server host 172.16.2.160 comaccess
The following example removes the host 172.16.2.160 from the SNMP trap recipient list:
WAE(config)# no snmp-server host 172.16.2.160
Related Commands (config) snmp-server community
(config) snmp-server contact
(config) snmp-server enable traps
(config) snmp-server group
(config) snmp-server location
(config) snmp-server mib
(config) snmp-server notify inform
(config) snmp-server user
(config) snmp-server view
snmp trigger