Specifications

3-331
Cisco Wide Area Application Services Command Reference
OL-11817-01
Chapter 3 CLI Commands
(config) policy-engine application map basic name
(config) policy-engine application map basic name
To configure the application policy with the basic policy map name, use the policy-engine application
map basic name global configuration command.
policy-engine application map basic name app-name classifier classifier-name {action
{optimize {DRE {yes compression {LZ [accelerate {CIFS-adaptor | MS-port-mapper}] |
none} | no} | full} | pass-through [accelerate {CIFS-adaptor | MS-port-mapper}]} | disable
action {optimize {DRE {yes compression {LZ [accelerate {CIFS-adaptor |
MS-port-mapper}] | none} | no} | full} | pass-through [accelerate {CIFS-adaptor |
MS-port-mapper}]}}
Syntax Description
Command Modes global configuration
Device Modes application-accelerator
Usage Guidelines Use the policy-engine application map basic name global configuration command to configure the
application policy with the basic policy map name.
To view WAFS dynamic accept or deny list entries, use the show policy-engine application dynamic
command.
app-name Application name.
classifier Specifies the name of the application traffic classifier.
classifier-name Name of the classifier.
action Specifies whether to optimize the traffic or allow it to pass through.
optimize Applies general optimization.
DRE Enables or disables DRE optimization.
yes Enables DRE optimization.
compression Applies compression.
LZ Applies Lempel-Ziv (LZ) compression.
accelerate Accelerates the traffic using a special adapter.
CIFS-adaptor Accelerates the traffic using the CIFS accelerator.
MS-port-mapper Accelerates the traffic using the Microsoft EndPoint Port Mapper
(EPM).
none Does not apply any compression.
no Disables DRE optimization.
full Applies full generic optimization.
pass-through Allows traffic pass through with no optimization.
disable action Disables optimization or pass-through.