Specifications

3-297
Cisco Wide Area Application Services Command Reference
OL-11817-01
Chapter 3 CLI Commands
(config) interface
Defaults No default behavior or values
Command Modes global configuration
Device Modes application-accelerator
central-manager
Usage Guidelines The interface command contains an option for FibreChannel; however, the FibreChannel interface is
not supported for WAAS devices. The interface FibreChannel command is not documented in this
Command Reference.
To configure an interface bandwidth on a WAAS device, use the bandwidth interface configuration
command. The bandwidth is specified in megabits per second (Mbps). The 1000 Mbps option is not
available on all ports. Using this option automatically enables autosense on the interface. You cannot
change the interface speed on a WAE-7320 model that has an optical Gigabit Ethernet interface. Gigabit
Ethernet interfaces only run at 1000 Mbps for a WAE-7320. For newer models of the WAAS device (for
example, the WAE-611 or WAE-7326) that have a Gigabit Ethernet interface over copper, this restriction
slot/grpnumber/ Slot and inline group number for the selected interface.
lan Specifies that you are configuring the LAN port on the inline network
adapter.
wan Specifies that you are configuring the WAN port on the inline network
adapter.
autosense (Optional) Sets the inline port adapter LAN interface to automatically
sense the interface speed.
bandwidth (Optional) Sets the bandwidth of the specified interface.
10 Sets the bandwidth of the interface to 10 megabits per second (Mbps).
100 Sets the bandwidth of the interface to 100 Mbps.
1000 Sets the bandwidth of the interface to 1000 Mbps.
full-duplex (Optional) Sets the interface to full-duplex operation.
half-duplex (Optional) Sets the interface to half-duplex operation.
Note We strongly recommend that you do not use half-duplex
connections on the WAE or on routers, switches, or other devices.
PortChannel Selects the EtherChannel of interfaces to configure.
1 Sets the port-channel interface number to 1.
2 Sets the port-channel interface number to 2.
errors Specifies the maximum error number.
max-error-number Maximum number of errors.
ip Specifies the IP address of the interface.
ip_address IP address of the interface.