Specifications

3-296
Cisco Wide Area Application Services Command Reference
OL-11817-01
Chapter 3 CLI Commands
(config) interface
access-group Configures access control for IP packets on this interface using access
control list (ACL).
acl_num Numeric identifier that identifies the ACL to apply to the current interface.
For standard ACLs, the valid range is 1–99; for extended ACLs, the valid
range is 100–199.
acl_name Alphanumeric identifier of up to 30 characters, beginning with a letter that
identifies the ACL to apply to the current interface.
in Applies the specified ACL to inbound packets on the current interface.
out Applies the specified ACL to outbound packets on the current interface.
address Sets the interface IP address.
ip-address IP address of this interface.
netmask Netmask of this interface.
secondary (Optional) Specifies that the configured address is a secondary IP address.
If this keyword is omitted, the configured address is the primary IP
address.
dhcp (Optional) Sets the IP address to that negotiated over Dynamic Host
Configuration Protocol (DHCP).
client-id (Optional) Specifies the client identifier.
id Client identifier.
hostname (Optional) Specifies the hostname.
name Hostname.
mtu (Optional) Sets the interface Maximum Transmission Unit (MTU) size.
mtusize MTU size in bytes (88–1500).
shutdown (Optional) Shuts down this interface.
standby (Optional) Sets standby interface configuration commands.
grpnumber Standby group number (1–4).
priority (Optional) Sets the priority of an interface for the standby group.
priority Interface priority for the standby group (0–4294967295).
InlineGroup Sets the InlineGroup of interfaces to configure.
slot/grpnumber Slot and inline group number for the selected interface. The group number
for the inline feature is either 0 or 1 (each adapter has 2 grouped pairs).
failover (Optional) Modifies failover parameters.
timeout Sets the maximum time for the inline group of interfaces to transfer traffic
to another port in the group after a failover event.
1 Number of seconds before failover occurs.
3 Number of seconds before failover occurs.
5 Number of seconds before failover occurs.
inline (Optional) Enables inline interception for an InlineGroup of interfaces.
vlan (Optional) Modifies the VLAN list parameters.
all Applies the command to all tagged and untagged packets.
native Specifies untagged packets.
vlan_list Comma-separated list of VLAN IDs. Restricts the inline feature to the
specified set of VLANs.
InlinePort Sets an inline port adapter interface to configure.