Specifications

3-279
Cisco Wide Area Application Services Command Reference
OL-11817-01
Chapter 3 CLI Commands
(config) clock
Defaults No default behavior or values
Command Modes global configuration
Device Modes application-accelerator
central-manager
Usage Guidelines To set and display the local and UTC current time of day without an NTP server, use the clock timezone
command with the clock set command. The clock timezone parameter specifies the difference between
UTC and local time, which is set with the clock set EXEC command. The UTC and local time are
displayed with the show clock detail EXEC command.
Use the clock timezone offset command to specify a time zone, where timezone is the desired time zone
entry listed in the table below and 0 0 is the offset (ahead or behind) UTC is in hours and minutes. (UTC
was formerly known as Greenwich mean time [GMT]).
WAE(config)# clock timezone timezone 0 0
Note The time zone entry is case sensitive and must be specified in the exact notation listed in Table 3-91.
When you use a time zone entry from the time zone table, the system is automatically adjusted for
daylight saving time.
Ta b l e 3-91 Time Zone—Offsets from UTC
Time Zone Offset from UTC
Africa/Algiers +1
Africa/Cairo +2
Africa/Casablanca 0
Africa/Harare +2
Africa/Johannesburg +2
Africa/Nairobi +3
America/Buenos_Aires –3
America/Caracas –4
America/Mexico_City –6
America/Lima –5
America/Santiago –4
Atlantic/Azores –1
Atlantic/Cape_Verde –1
Asia/Almaty +6
Asia/Baghdad +3
Asia/Baku +4