Specifications

3-256
Cisco Wide Area Application Services Command Reference
OL-11817-01
Chapter 3 CLI Commands
(config) adapter
(config) adapter
To enable the EndPoint Mapper (EPM) service, use the adapter global configuration command. To
disable the EPM service, use the no form of the command.
adapter epm enable
Syntax Description
Defaults The EPM service is enabled by default when you upgrade to WAAS software release 4.0.3 and later
releases. The EPM service is disabled by default on new WAE appliances or when you restore the factory
default settings.
Command Modes global configuration
Device Modes application-accelerator
central-manager
Usage Guidelines Use the adapter epm enable command to enable EPM service when the Microsoft PortMapper adapter
is installed.
Examples The following example enables the EPM service:
WAE(config)# adapter epm enable
Related Commands show adapter
show statistics epm
epm Specifies the Microsoft PortMapper adapter.
enable Enables the EPM service.