Specifications

CHAPTER

2-1

Cisco Wide Area Application Services Command Reference

OL-11817-01

Cisco WAAS Software Command Summary

This chapter summarizes the Cisco WAAS 4.0.7 software commands.

Table 2-1 lists the WAAS commands (alphabetically) and indicates the command mode for each

command. The commands used to access configuration modes are marked with an asterisk. Commands that

do not indicate a particular mode are EXEC mode commands. The same command may have different

effects when entered in a different command mode, so they are listed and documented separately. (See

Chapter 1, “Using the WAAS Command-Line Interface” for a discussion about using CLI command

modes.)

In Table 2-1, in the Device Mode column “All” indicates that the particular CLI command is supported

in both central manager mode and application accelerator mode.

Note When viewing this reference online, click the name of the command in the left column of the table to

jump to the command page, which provides the command syntax, examples, and usage guidelines.

Throughout this book, the term WAAS device refers collectively to a WAAS Central Manager and a

WAE. The term WAE refers collectively to the supported WAE platforms that are running the WAAS

software.

Ta b l e 2-1 Command Summary

Command Description CLI Mode Device Mode

(config) aaa accounting Configures AAA accounting. global configuration All

(config) adapter Enables the EndPoint Mapper (EPM) service. global configuration application

accelerator

(config) alarm

overload-detect

Configures the detection of alarm overload. global configuration All

(config) asset Configures the tag name for the asset tag

string.

global configuration All

(config) authentication Configures administrative login

authentication and authorization parameters.

global configuration All

(config) auto-register Enables the discovery of a primary interface

on a WAE and its automatic registration with

the WAAS Central Manager through DHCP.

global configuration application

accelerator

(config-if) autosense Sets the current interface to autosense. interface configuration All